Installation Guide
Pulling in the screen

LIFT THE ROLLS FROM THE GROUND

.

SECURE PULLING IN WITH THE RIGHT ANGLE

Pulling in the screen using the right angle and tube

• The best way to pull in is by using as little tension as possible. We recommend using a steel tube in a holder with bearings or a Teflon holder to pull in the screens with minimum friction. This will reduce the stretching of the screen while pulling it in.
  
  Note: Foil rolling devices are not recommended as they can damage the screen.
  
  
• When pulling in the screen, make sure that the angle is greater than 110°, and that the screen is pulled over a smooth plastic tube Ø 125 mm or larger.
  
  
• Facilitate unrolling the screen by guiding it on both sides manually.
  
  
• While pulling in, we recommend keeping the screen as wide as possible; this helps maintain the screen's structure.

WORK IN PAIR (2 PEOPLE REQUIRED)

Pulling-in Wide

• While pulling in the screens, watch out for sharp objects like heating installations, crop-hooks, profiles, etc.
  
  
• * Unless pieces are cut to length when there is more than one sheet on a roll, you’ll find two blue lines marking the border between the sheets.
  
  In between these lines, you will find a tape with a white cutting line. The screen can be cut along the cutting line with a hot knife or power scissors.
  
  (*) for the American markets, pieces are always cut to length